SEALED DIE-CAST ALUMINUM CASE WITH FLANGE
|While stock lasts|
Enclosures for sensitive electronic assemblies and for pneumatic, hydraulic and electrical devices in commercial and industrial environments. These enclosures provide effective EMI and RFI shielding. Designed according to IP65 of IEC529 and NEMA4 (dust- and hoseproof).
The mounting holes and the fixing screws for the lid are located outside the sealed area, which prevents moisture and dust from entering the enclosure.
The lid incorporates a recessed neoprene gasket.
Bosses on the internal base allow the fixing of PCB's and are suited for an earthing connection, etc...
Internal guide slots allow vertical PCB mounting.
The lid-mounting screw holes are threaded and the screws themselves are captive and recessed.
Two or four holes make horizontal PCB mounting possible.
- material: aluminum alloy
- dimensions: 3 1/2" x 1 3/8" x 1 3/16"
- L: 113.9mm
- L1: 89.1mm
- W: 35.1mm
- W1: 25mm
- H: 30mm
- C1: 79.6mm
- C2: 25.4mm
- C3: 101.8mm
- C4: -
- S1: 36mm
- L2: 73mm
- L3: -
- L4: 85.8mm
- W2: 19mm
- W3: 27,8mm
- W4: 31.8mm
- H1: 23.6mm
Warning: this product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to: www.P65Warnings.ca.gov/product.
All registered trademarks and trade names are properties of their respective owners and are used only for the clarification of the compatibility of our products with the products of the different manufacturers.
Due to constant product improvements the actual product appearance might differ from the shown images. Product images are for illustrative purposes only.