Belgium - English (UK)
Change
Based on your location we recommend you to visit www.velleman.eu

DIY STARTER KIT FOR ARDUINO®

VMA501
Support
Downloads (13)
Support
Level 4: Advanced
Compare

Features

  • This basic kit includes: 1 x ATmega328 UNO DEVELOPMENT BOARD (VMA100)
  • 15 x LED (different colors)
  • 8 x 220 Ohm resistor (RA220E0)
  • 5 x 1K resistor (RA1K0)
  • 5 x 10K resistor (RA10K0)
  • 1 x 830 hole breadboard
  • 1 x RGB LED module (VMA318)
  • 4 x 4-pin Key switch
  • 1 x Active buzzer (VMA319)
  • 1 x Passive buzzer
  • 1 x 1838 IR Infrared 37.9Khz Receiver (VMA317)
  • 1 x Infrared remote control
  • 1 x infrared sensor diode
  • 1 x LM35 temperature sensor (LM35DZ)
  • 2 x Ball tilt switch (similar to MERS4 & MERS5)
  • 3 x Photosenitive resistor LDR (similar to LDR04)
  • 1 x 74HC595 Shift register (HC595)
  • 1 x Battery holder for 6 AA battery's (similar to BH363B)
  • 1 x 8*8 LED Matrix display
  • 1 x single digit 7 segment LED display
  • 1 x 4 digit 7 segment LED display
  • 30 x Breadboard jumper wire
  • 1 x USB cable

All registered trademarks and trade names are properties of their respective owners and are used only for the clarification of the compatibility of our products with the products of the different manufacturers.
Due to constant product improvements the actual product appearance might differ from the shown images. Product images are for illustrative purposes only.

Belgium - English (UK)

Change