Belgium - English (UK)
Change
Based on your location we recommend you to visit www.velleman.eu

DMX512 MODULE

VMA432
Support
Downloads (2)
Support
Compare

This Arduino add-allows you to use the Arduino as a DMX master device (transmitter). This board is a simple circuit based around a driver chip (MAX-485 or SN 75176). With XLR 3 pin male DMX output connector. Pin1 = Signal Common, Pin2 = Data-, Pin3 = Data+ The board converts the Arduino signal voltage according to DMX (RS485). Impedance is 100 Ohm.

Specifications

  • working voltage: 5 V
  • DMX connection: XLR 3 pin
  • dimensions: 40 x 20 x 30 mm
  • weight: 10 g

Warning: this product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to: www.P65Warnings.ca.gov/product.

All registered trademarks and trade names are properties of their respective owners and are used only for the clarification of the compatibility of our products with the products of the different manufacturers.
Due to constant product improvements the actual product appearance might differ from the shown images. Product images are for illustrative purposes only.

Belgium - English (UK)

Change